$75,900
190.8 miles away - WAKARUSA, IN
10′ tub flare (i.e. 10' width at flare),Tub floor built of 10 gauge, side walls of 12 gauge steel,44″ (111.76 cm) heavy-duty hammermill located at rear of tub It uses 64 hammers, mounted on 1¼″ (3.18 cm) case-hardened rods, and 3/8″ thick rotor plates 8-belt drive system, spring-tensioned (to maintain constant tension as belts wear & stretch The drive is via PTO (1,000 rpm), through multiple belts, using either a 1-3/8″ × 21-spline or 1-3/4″ × 20-spline shaft ub drive is via hydraulic motor, with a continuous toothed chain gear around tub, tensioned by dual spring tensioners Bolt-in mill grate / slug bar combination; operator can adjust the number of grate/slug bars depending on grinding conditions Screen options from 1/8″, 3/16″, ¼″ up to larger hole sizes (up to 8″) to control output particle size Dual augers (12″ diameter × 4′ length) move ground material to the discharge / stacking conveyor Hydraulic folding, stacking conveyor: 21′ long × 24″ wide, capable of stacking to ~14′-9″ height at a 40° incline Requires a minimum of 150 HP, up to 315 HP on PTO Hydraulic output required: ~ 8 gpm at 1,500 psi (for conveyor & tub tilt / fold circuits) EXTRA SCREENS INCLUDED.
$49,500
966.2 miles away - ALTUS, OK
Used 2024 DuraTech 2665 Tub Grinder This machine offers, heavy-duty chain conveyor with more durable chain and heavier drive shafts. Rotor is driven through the chain case, which reverses the direction of the rotor for right side discharge and also increases the rotor speed by 30%. Two-stage bale loader that easily picks up bales without disturbing other bales and gouging the ground. Heavy-duty tubular frame construction designed to carry heavy bales. Rotor access door gives you easy access to rotor for service and maintenance. Adjustable slug bars allow you to easily position the bale from the rotor and hammers allowing you to take any size bite out of the bale. For more information, contact Dylan Rollins with Western Equipment at (580)-482-6666 or [email protected]!
$27,500
930.2 miles away - VALENTINE, NE
D&W 5 BALE PROCESSOR WITH BALE RETRIEVER ARM INCLUDED GOOD WORKABLE MACHINE
$10,900
1480.0 miles away - MANHATTAN, MT
D&W H Combo round bale picker / hay buster processor Carries 6 bales Feeds 5 bales
$9,500
209.3 miles away - SCIENCE HILL, KY
$9,500
164.6 miles away - JONESVILLE, MI
10 FT RAKE, HYD DUMP, 1 CU YARD CAPACITY, HANDLES 2-15" ROCKS
Filter by State
